16 17
model no. 054-0252-2 | contact us 1-888-670-6682
Insert the large end of the hose into
the blower connection in the top of the
motor housing.
Switch on the power.
This Wet/Dry Vacuum has blowing capabilities. To use the blower feature follow the
instructions listed.
Ensure the power switch is turned off
and plug in the power supply.
The unit will now blow through the
vacuum hose and can be used to clear
obstructions within the hose.
1
3
2
4
WARNING!
If after a few seconds the hose continues to be blocked, turn off
the unit and clear the hose manually.
WARNING!
Keep bystanders clear of blowing debris.
Wear a dust mask if blowing creates dust that might be inhaled.
Disconnect the hose from the tank.
2
Ensure that the power cord is
disconnected from the outlet.
Undo the clasps and remove the top
section from the tank.
1
3
MAINTENANCE
Clear all dirt or debris from the tank
and hose.
4
BLOWER OPERATION
To Next Page
Loading...
General