MAINTENANCE
BEFORE EACH USE
1. Inspect the reciprocating saw, the on/off switch, the cord and the accessories
for damage.
2. Check for damaged, missing, or worn parts.
3. Check for loose screws, misalignment or binding of moving parts, or any other
condition that may affect the operation.
4. If abnormal vibration or noise occurs, turn the tool off immediately and have
the problem corrected before further use.
5. Unplug the tool from power source before cleaning or performing any
maintenance. Using compressed air may be the most effective cleaning
method. Always wear safety goggles when cleaning tools using compressed air.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high-
grade lubricant for the life of the unit under normal conditions. Therefore, no
further lubrication is required.
MAINTENANCE
WARNING!
• Do not allow brake fluids, gasoline and petroleum-based products,
penetrating oil, etc. to come into contact with plastic parts. These
substances contain chemicals that can damage, weaken, or destroy plastic.
• When servicing, use only identical replacement parts. The use of any other
parts may create a hazard or cause damage to the product.
• Use only accessories that are recommended for this reciprocating saw
by the manufacturer. Accessories that may be suitable for one tool may
become hazardous when used with another tool.
• If the supply cord is damaged, it must be replaced by a specially prepared
cord available through the service organization.
• To ensure safety and reliability, all repairs should be performed by a
qualified service technician.
To Next Page
Loading...
