LIFT CORPORATION Sht. 2 of 10 DSG# M-18-02 Rev. - Date: 10/11/18
© MAXON Lift Corp. 2018
`
To prevent injury, Liftgate should be placed on level ground in shipping position
before installing mounting plate kit.
WARNING
!
NOTE: Install this mounting plate kit before mounting Liftgate on vehicle. After this kit
is installed, refer to GPTLR Series Installation Manual (GPTLR-25, GPTLR-33,
GPTLR-44 and GPTLR-55) to install the Liftgate.
1. Position liftgate on level ground
with access to the original mounting plates
(FIG. 2-1). Unbolt the original mounting
plate from bracket on the LH side of the
main frame (FIG. 2-1). Remove mounting
plate. Discard the bolts and fl ange lock
nuts. Repeat for RH side.
UNBOLTING MOUNTING PLATE
(LIFTGATE ON THE GROUND)
FIG. 2-1
MOUNTING
PLATE
FLANGE BOLT
(6 PLACES)
FLANGE LOCK NUT
(6 PLACES)
LH MOUNTING
PLATE
NOTE: Gravity down models have plastic ties to secure cylinder vent tubes and hydrau-
lic hoses to the main frame. Remove plastic ties so the tubes and hoses can be
moved enough to remove and replace mounting plates.
To Next Page
Loading...
