WARNING:
◎ Ensure all electrical connections (including protective gas and grounding) have
been adequately connected before usage. It is recommended to tighten and
secure all connectors with screws whenever possible..
◎ Avoid directly looking at the laser outlet during operation. Always wear
appropriate safety gear such as protective eyewear, soundproof earplugs, and
masks before operating the laser.
◎ Prior to wiring, make sure all the power switches of the laser are turn off.
Startup Procedure:
(1) Connect the power input to the specified voltage, phase, and frequency.
(2) Securely lock the connection to the loop interface and connect the wire-feeding power
cord to the FEEDER interface.
(3) Attach the protective gas pipe (outer diameter 6mm) to the gas inlet port and open the
gas valve.
(4) Switch on the power on the laser's rear panel.
(5) Release the emergency stop switch on the laser's front panel.
(6) Tap the touch screen to access the software interface, and adjust the required
parameters (laser power, swing amplitude, swing frequency, air blowing and closing air delay,
power increasing and decreasing slowly, light output mode, etc.).
(7) Set the air valve mode to normally open, and adjust the protective gas flow to 15-20 L/min.
(8) Attach the alligator clip to the workpiece intended for welding.
(9) Activate the laser start button and the laser enables switch.
(10) Press and hold the torch head switch to emit light
12-Startup Steps for Laser Operation
.
To Next Page
Loading...
Need help?
General
