9
Chapter 2 General Safety Information
instruments).
(7) Please use the defocus method to mark on the high-reflection material,
otherwise the laser will be directly damaged.
(8) For collimated output, please do not touch the output lens or any solvent
for cleaning. Use lens tissue paper to clean the output lens. After use, please
replace the protective cover of the sight.
WARNING :
◎
Make sure that the individual protective equipment meets the output power
and wavelength range of the laser.
◎
Never look directly into the optical ber or the collimator, and Use appropriate
laser safety eyewear when operating this device.
◎
Optical damage may result from failure to comply with the above instructions.
Such damage is not covered by the warranty.
WARNING:
◎
Use of controls or adjustments or performance of procedures other than those
set forth in this User’s Guide and related documents may result in hazardous
radiation exposure.
4 .Electrical Operating Instructions
Q-Switched pulsed ber laser (MFP 5W-70W) Series supply voltage:24VDC.
To Next Page
Loading...
Need help?
General
