13
Chapter 2 General Safety
Information
（
11
）
If the equipment is operated in a manner not specied in this document,
the protection devices and performance of the equipment may be impaired and
the warranty will be voided.
CAUTION :
◎
The output of the laser is delivered through a lens with an anti-reflection
coating. If the backward-stage light path of your laser has the optical lens,
please strictly inspect the lens of the output head and the backward-stage lens
of the laser, and ensure that there is no dust and any other impurity on the lens.
Please note that any macroscopic attachment may cause extreme damage to
lens or burn the laser or any backward-stage light path equipment.
◎
For cleaning instructions of the lens, please refer to the "Optical Fiber
Connector Inspection and Cleaning Guide".
◎
Hot or molten pieces of metal may be produced when the laser is under
operation. Exercise caution if debris is produced in operation.
◎
When implement commissioning and calibration of laser output, it’s necessary
to set the quality of the spot emitted from the laser at low power levels via an
infrared viewer, and then gradually increase the output power.
WARNING :
◎
Make sure that the individual protective equipment meets the output power
and wavelength range of the laser.
◎
Never look directly into the optical fiber or the collimator, and make sure you
wear the safety protective glasses in each operation.
4.Electrical Operating Instructions
We strongly recommend that you read the following procedures before operating
the laser:
(1) Please ensure that the equipment casing is well grounded, and any
interruption in the grounding circuit may cause personal injury;
To Next Page
Loading...
Need help?
General
