17
Chapter 2 General Safety
Information
to follow the lens cleaning inspection process.
◎
Please be careful with the hot phenomenon or molten metal particles that
may be generated during the cleaning operation of the hand-held laser welding
machine.
◎
When debugging and calibrating the output of the hand-held laser welding
machine, it is necessary to set the hand-held laser welding machine to detect
the spot quality of the laser output through the indicating red light under the
condition of no laser light, and then turn on the laser if there is no abnormality.
WARNING :
◎
Reasonable selection of safety protection equipment according to the laser
output power and wavelength requirements.
◎
Do not look directly at the tip of the gun, and ensure that safety glasses are
always worn during each operation.
4.Electrical Operating Instructions
Maxphotonics strongly recommends that you read the following operating
points before operating the handheld laser welding machine:
(1) Please ensure that the equipment shell is well grounded, any interruption in
the grounding loop may cause personal injury;
(2) Please make sure that the power supply connected to the device is
connected to the protective ground before use;
(3) In order to reduce the risk of re, when necessary, the replacement of line
fuses can only be of the same type and level, and cannot be replaced by other
fuses or materials;
(4) Make sure that the input AC voltage of the handheld laser welding machine is
the normal AC mains voltage (single-phase voltage 200-240VAC), and the wiring
is correct. Any wrong wiring method may cause personal or equipment injury;
(5) Except for the gun head consumables, the user does not need to repair
To Next Page
Loading...
Need help?
General
