18
Chapter 2 General Safety Information
the parts, components or components by themselves, and all maintenance
operations need to be completed by professionals from Maxphotonics;
(6) It is strictly forbidden to disassemble and assemble the hand-held laser
welding machine without authorization, and damage the relevant labels,
otherwise there will be a danger of electric shock or burns;
(7) There should be no ammable materials near the welding area. The heat and
sparks generated during the welding process may cause re or explosion. Laser
welding can only be performed in areas free of combustible materials.
(8) Never weld on containers containing ammable or combustible materials. If
the contents of a container are unknown, you should assume they are ammable
or combustible. Fire extinguishers should be nearby, easily accessible, and
personnel trained to use them.
(9) Any product that has been disassembled without permission no longer enjoys
the warranty rights.
WARNING :
◎
The input voltage of the hand-held laser welding machine is single-phase
alternating current (200-240VAC), and there is a danger of electric shock. All
associated cables and connections are potentially hazardous.
5.Operating Environment Requirements for Handheld Laser Welding
Machines
This equipment is commonly used in: (1) below 2000 meters above sea level, (2)
overvoltage category II, (3) environmental pollution degree 2, (4) dry location.
For more information, please refer to the product specications.
Humidity: Do not expose the device to high humidity (>85% humidity)
Cooling and temperature: The laser unit is cooled by air. Operating at higher
temperatures accelerates aging, increases threshold current and reduces slope
efciency. If the device overheats, do not use it and call Maxphotonics for help.
To Next Page
Loading...
Need help?
General
