866.4.Maxtec www.maxtec.com24
13.0 Electromagnetic Compatibility
The information contained in this section (such as separation distances) is in
general specifically written with regard to the MaxBlend2 Monitor. The numbers
provided will not guarantee faultless operation but should provide reasonable
assurance of such. This information may not be applicable to other medical
electrical equipment; older equipment may be particularly susceptible to
interference.
NOTE: Medical electrical equipment requires special precautions regarding
electromagnetic compatibility (EMC) and needs to be installed and put into service
according to the EMC information provided in this document and the remainder of the
instructions for use this device.
Portable and mobile RF communications equipment can affect medical
electrical equipment.
Cables and accessories not specified within the instructions for use are not
authorized. Using other cables and/or accessories may adversely impact
safety, performance and electromagnetic compatibility (increased emission
and decreased immunity).
Care should be taken if the equipment is used adjacent to or stacked with
other equipment; if adjacent or stacked use is inevitable, the equipment
should be observed to verify normal operation in the configuration in which it
will be used.
The MaxO2ME is suitable for use in all establishments other
than domestic and those directly connected to the public
low-voltage power supply network that supplies buildings
used for domestic purposes.
The MaxO2ME uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.*
ELECTROMAGNETITC ENVIRONMENT
COMPLIANCE
ACCORDING TO
Group 1
Class A
Class A
Complies
Voltage fluctuations / flicker
(IEC 61000-3-3)
Harmonic emissions
(IEC 61000-3-2)
CISPR Emissions
Classification
RF emissions (CISPR 11)
EMISSIONS
This equipment is intended for use in the electromagnetic environment specified below.
The user of this equipment should assure that is used in such an environment.
ELECTROMAGNETIC EMISSIONS
To Next Page
Loading...
Need help?
General