Maxx Cold SELECT MXSF-23FD User Manual

Page 17 of 58
TROUBLESHOOTING GUIDE
BEFORE CALLING FOR SERVICE
If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If the problem
persists, see Troubleshooting below. The problem may be something very simple that can be solved without a service
call.
TROUBLESHOOTING
Fault Probable Cause Action
Compressor is Not Running
Fuse blown or circuit breaker tripped
Replace fuse or reset circuit
breaker. If replacement of fuse or
reset of circuit breaker doesn’t
correct the problem contact a
qualified service technician.
Power cord unplugged Plug in power cord
Thermostat set too high
Set thermostat to lower
temperature
Cabinet Temperature is too
Warm
Thermostat is set too high
Set thermostat to lower
temperature.
Airflow is blocked
Re-arrange products to allow for
proper air flow. Make sure there
is at least four inches of clearance
from the fan
Low refrigerant levels
Contact a
qualified service
technician
to check refrigerant
levels
Door is slightly ajar
Make sure door is completely
closed.
Interior Light is Not Working
Poor switch connection
Turn off light swi
tch and turn it
back on.
Bulb is not connected
Make sure the bulb is correctly
inserted in the socket.
Bulb has burned out
Replace the bulb. If replacement
of bulb doesn’t correct the
problem contact a qualified
service technician.
Condensation is Collecting
on the Cabinet and/or Floor
Gasket is not sealing properly
Clean, repair, or replace the
gasket as necessary

Maxx Cold SELECT MXSF-23FD Specifications

General

Brand	Maxx Cold
Model	SELECT MXSF-23FD
Category	Commercial Food Equipment
Language	English