Maxx MIM-50 - Page 14

13
2.Low production
Problem
kinds
Check part
or point
Possible Cause
Probable Correction
Cooling
System
Refrigerant
Refrigerant leaks
partially
Recharge.
Condenser
The condenser may be
dirty.
Clean the condenser.
The ambient
temperature
The ambient
temperature is high or
too low
Check the ambient and air flow
Fan
The fan is dirty or
damaged
Clean or repalce
Hot gas valve
Hot gas valve
performance poor,
leads to few ice is
produced.
Replace the hot gas valve
Electronic
controller
The setting
temperature of
Electronic controller
is low.
See the service manual "adjust
the size of ice cubes"
Sensor
The sensor of
temperature damages
Replace the sensor of
temperature.
Water
System
Water
distribution
tube
The water distribution
tube blocks
Clean the water distribution
tube
Water line
The water quality is
too poor. The water
line blocks
Using a filter apparatus
installed in front of the water
inlet valve.
Silica gel
tubes
The silica gel tubes
distort, lead to block.
Make the silica gel tubes resile
Floater valve
The floater valve
leaks. Lead to few ice
produced.
Repair or replace
Wheel
The icemaker is not
proper leveled.
See installation
3.Ice Cube is not OK
Problem
kinds
Check part
or point
Possible Cause
Probable Correction
Condenser
The condenser is dirty
or the air grills are
covered
Clean the condenser. Leave
space around the machine