Maxx SP5 S - Reassemble Housing (SP5 C, SP5 S-SP5 S-MS); Decommissioning and Storage

Maintenance and cleaning
- 54 -
5.3.5 G Reassemble the housing (SP5 C, SP5 S – SP5 S-MS)
Close the housing lid as described in figure 20, page 20, figure 24, page 23
and figure 25, page 23.
5.4 Decommissioning and storage of device
1. Remove all liquids and, if necessary, solid matter from the feed and
drain lines and sample containers and clean as required.
2. Close all active programs.
3. Switch off the equipment (disconnect from mains)