MAXX BENCH | WILKES-BARRE PA | WWW.MAXXBENCH.COM
Inspect All Fasteners
Be sure to check fasteners at bolted joints to make sure the connections are secure. If a fastener is loose but in good condition, retighten it. If
you are concerned about the integrity of the fastener, remove it, clean the threads and inspect it for any damage such as cracks, bad threads,
corrosion, or rust. Reinstall the fastener if it appears to be in good condition. Otherwise, remove the equipment from service until a new
fastener can be installed properly. You can order new fasteners from Customer Support.
Important: Fastener quality and specifications vary considerably. Replace only with the Maxx Bench approved fastener specifically
engineered for the precise application. Failure to do so will void the Maxx Bench Limited Warranty.
Maxx Bench products are assembled with Grade 5 fasteners or better. Periodically inspect all nuts, bolts, hex key bolts, screws, and other
fasteners to ensure they are tight and installed correctly.
page 18
extended descriptions and definitions
6.2 maintenance
To Next Page
Loading...