MAXX BENCH | WILKES-BARRE PA | WWW.MAXXBENCH.COM
You must review and follow the instructions in this guide. If
you do not assemble and use the Maxx Bench according to
the following guidelines, you could void the Maxx Bench
Limited Warranty.
3.4 Required Tools
Tools that you need to obtain before assembling the unit
include:
❏ Two 19-mm wrenches
❏ Two 8-mm hex keys
❏ Wire tie cutter (cuts plastic tie wraps)
Note: Use box-end, open-end or standard crescent
wrenches.
3.5 Installation Requirements
Follow these installation requirements when assembling the unit:
•
Fill out and submit the warranty registration card online.
•
Provide ample space around the machine. Open space
around the machine allows easier access.
•
Set up the Maxx Bench on a solid, flat surface. A smooth, flat
surface under the unit helps keep it level.
•
Insert all fasteners in the same direction. For aesthetic
purposes, insert all the fasteners in the same direction unless
specified (in text or illustrations) to do otherwise.
•
Leave room for adjustments. Tighten fasteners (such as
screws, nuts, and bolts), so the unit is stable, but leaves room
for adjustments. Do not fully tighten fasteners until instructed
(in the steps) to do so.
page 6
ASSEMBLYSAFETY
To Next Page
Loading...