February, 2019 eMAX-LP1502-Man Page 16 of 20
Appendix A - Configuring the eMAX-LP Controllers
The eMAX-LP controllers include an internal web page for configuring the communication parameters of
the device. It is recommended that the device be preconfigured in a controlled environment before
installing the device on site.
Default IP is 192.168.6.12
Default user and password is admin and password
Configuration of the eMAX-LP controller requires the following information.
• IP Address _____.______.______._____
• Subnet Mask _____.______.______._____
• Gateway IP _____.______.______._____
Connecting to the eMAX-LP controller
1. Connect the device to a computer using a standard network cable.
2. Set the computer’s IP to a Statis IP Address of 192.168.6.10.
3. At the eMAX-LP Controller, be sure to turn dipswitch #1 to the ON position. This enables the use of
the DEFAULT Login credentials, and will time out in 5 minutes.
4. Connect to the device from your browser using http://192.168.6.12. The following screens will
appear.
This message may be different, depending on the version of Operating System that you have installed.
First Click on “ Details “, which will tell you that your PC does not recognize the Web Pages’s Security
Certificate. This is Normal. Then click on “ Go on to the webpage “.
To Next Page
Loading...
Need help?
General