EN
12
DANGER – Danger of Electric
Shock
■ Keep children and animals away from
the connecting cable when it is con-
nected to the mains power.
■ Never immerse the connecting cable
in water or other liquids and ensure
that these components cannot fall
into water or become wet.
■ Never touch the connecting cable
with wet hands when it is connected
to the mains power.
■ Store the device only in closed rooms.
■ Do not store the device in rooms with
high humidity.
WARNING – Danger of Injury
■ Keep children and animals away from
the packaging material. There is a
danger of suffocation.
■ Make sure that the connecting cable
is always kept out of the reach of
small children and animals. There is a
danger of strangulation.
NOTICE – Risk of Damage to
Material and Property
■ Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
■ Do not use the device if water emerg-
es from a place other than the outlet
pipe.
■ Switch off the device and pull the
mains plug out of the plug socket if
an error occurs during operation or
before a thunderstorm.
■ Always pull the mains plug and never
the mains cable to disconnect the
device from the mains power.
■ Do not place heavy objects on the
device or the connecting cable.
■ Make sure that the connecting cable
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces.
■ Protect the device from naked fl ames,
extreme temperatures and impacts.
ASSEMBLY
Please Note!
■ Do not install in places where there
is a risk of frost!
■ Do not connect to another tap or
another device which might impede
the circulation of water.
■ The device must only be connected
to a cold water pipe. If there is both a
cold and a hot water connection, only
the cold water connection may be
used. If you have any questions or are
uncertain, consult a plumbing expert.
■ This device must be installed upright.
■ Make sure that the surface on which
the device is installed is stable.
■ Only connect the device to a plug
socket with a 16 A fuse that is prop-
erly installed. The mains voltage
must match the technical data of the
device.
The plug socket must also be readily
accessible after connection so that the
connection to the mains can quickly
be isolated.
■ Do not connect the device along with
other consumers with a high wattage
to a circuit in order to prevent over-
loading and a possible short circuit
(fi re). Make sure that the circuit is
designed to handle the power of the
device.
To Next Page
Loading...