EN
14
Connecting to the water pipe and power
line
A water hose with a hose screw
connection or an adapter with a
½“ internal thread is also re-
quired. Which connection piece
is required between the hose and
the water pipe depends on the
respective water pipe.
1. Screw the hose screw connection or
the adapter of the water hose(a) onto
the threaded pipe.
2. Fit the other end of the water hose to
the water pipe.
3. Open the water supply.
4. Move the lever(12) of the device to
water fl ow (turn downwards), turn the
outlet pipe to the left and right and
check all connections for any leaks.
Fix any leaks.
5. Only if there are no leaks should
you plug the mains plug into the plug
socket.
SETTING THE WATER
TEMPERATURE
PictureI shows the possible positions
of the lever(12) and the corresponding
settings:
• If the lever is at an angle of approx.
-45° to the main device, the water
fl ow is switched off.
• When the lever is turned downwards,
the fl ow of cold water increases.
• When it is turned upwards, the fl ow
of hot water increases. The water
temperature drops as the amount of
water fl owing in the hot water range
increases. When the device is operat-
ed in the hot water range, the display
shows the current water temperature.
Power is only consumed when
producing hot water. It is there-
fore not necessary to pull out the
mains plug to save electricity.
CLEANING AND
MAINTENANCE
Please Note!
■ Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. They may damage
the surfaces.
If the fl ow of water becomes weaker or
irregular, the water outlet on the outlet
pipe(2, 7) should be cleaned:
1. Unscrew the water outlet (PictureJ.)
2. Take out the fi lter insert and descale it
with a standard descaling agent.
3. Do not forget the sealing ring when
reassembling it!
To Next Page
Loading...