10. Connect all the wires and connectors to the corresponding outlets on the Roof
Panel. Be sure all the plugs are connected snug and tight. (see FIG-14)
FIG-14 Connecting cords/wires connectors
11. Make sure all steps are completed correctly. Next, plug in the power cord to your
wall outlet. Turn on the sauna at the control panel to confirm that the control panel
is responding. If the control panel responds accordingly, then proceed in putting the
Roof Cover onto the Roof Panel. Make sure to pull the power cord through the
corresponding hole in the Roof Cover. Proceed in screwing down the Roof Cover to
the Roof Panel. (see FIG 19)
FIG 19 Slip the power cord through Roof Cover
12. Attach the door handle and screw into place. If your unit came with any accessories
such as the cup holder or magazine rack, you can screw down
to the interior wall panel.
13. Enter the sauna and remove the protective masking tape from the TEMPERATURE
SENSOR. Situate the TEMPERATURE SENSOR so that it is vertical, pointing
downward. (see FIG 20)
Page 13
To Next Page
Loading...
Need help?
General
