11
Assembly
Pictures shown are for representation only and may not resemble your
exact model.
Please note the following:
A. You will need a Philips screwdriver, ladder, and two adults to assemble.
B. Do not plug any other appliances into the power supply of the sauna room other
than the designated sauna connections/plugs.
C. Assemble the sauna room on a completely level surface.
D. Do not spray or get water on the exterior/interior walls of the sauna room. If the floor
which the sauna will sit on is damp or wet, install a barrier between your floor and
the sauna floor to keep the sauna’s floor from becoming damp or wet.
E. Do not store flammable objects or chemical substances near the sauna.
F. 2-person and 3-person saunas are packed into two-to-three cartons. For example -
C/NO: 002 1 OF 3; C/NO: 002 2 OF 3; C/NO: 002 3 OF 3. (see FIG-1 & 1.2)
FIG-1 Cartons FIG-1.2 C/No.
1. Place the Floor Panel on a smooth/flat/level surface and make sure which side is the
front and which side is the back. The front of the floor has no quarter round trim
molding as do the other three sides. (see FIG-2)
FIG-2 Placing Floor Panel
To Next Page
Loading...
Need help?
General
