18
Additional Functions
Hand Pulse Sensors
Used for short-term pulse control. Cover the hand sensors with both hands. After a short while the current pulse
is shown in the display. Please also read the chapter “Pulse Measurement using Hand Sensors” and “Warning
on Heart Rate Measurement” in this manual.
Heart Rate Measurement
The cockpit of this treadmill is factory tted with a receiver for wireless heart rate measurement for which an
optional transmitter chest belt is needed. This chest belt must be 5 kHz frequency and uncoded. MAXXUS®
recommends using a POLAR® T34 Transmitting Belt. The use of Bluetooth chest belts is not possible. Please
also read the chapter “Pulse Measurement using Hand Sensors” and “Warning on Heart Rate Measurement” in
this manual.
Line-in Connection & Speakers
The cockpit of the treadmill is equipped with a line-in connection and speakers. The line-in cable (included)
allows you to connect an external music source (eg smartphone, MP3 player, etc.) and play the audio source
through the speakers. The volume is regulated via the externally connected device. Sound control via the cock-
pit is not possible.
USB Charging Port
Socket for a USB cable (not included)
Switching on the Treadmill
Connect the mains plug of the power cable to a grounded, individually fused 16 A socket installed by a specialist
then switch on the treadmill with the on / o key (located on the back of the motor housing).
Switching o the Treadmill
To switch o the treadmill, press the on / o key and then remove the mains plug from the socket.
CAUTION:
Before you switch o the treadmill always make sure that the incline is at level zero.
Quick Start
Turn on the treadmill and press the START key.
The treadmill starts automatically after a countdown and the exercise time starts to run. During training the user
can regulate the speed and incline directly using the SPEED and INCLINE keys. To end training, press the
STOP key two times.
Cockpit
To Next Page
Loading...
Need help?
General
