Need help?Do you have a question about the Maytag 30 Series and is the answer not in the manual?
General| Brand | Maytag |
|---|---|
| Series | 30 Series |
| Configuration | Top Load |
| Color | White |
| Energy Star Certified | No |
| Spin Speed | 700 RPM |
| Deep Fill Option | Yes |
| Power Source | Electric |
Crucial safety instructions and warnings for operating and servicing the washer.
Guidelines to prevent damage to sensitive electronic components from ESD.
Terms and conditions of the limited warranty for appliance parts.
Criteria for selecting an installation location and setting up the drain system.
Essential electrical specifications and safe grounding procedures for the washer.
Initial setup steps for the washer, including loading capacity and model differences.
Instructions for configuring the washer's control settings and options.
Diagram illustrating the location of major internal components within the washer.
Comprehensive guide to removing the entire tub and spin basket assembly.
Further steps for removing the tub and spin basket assembly, including weights.
Final steps for separating tub halves and accessing bearings and seals.
Important checks and considerations before testing any washer component.
Procedure for testing the resistance of the inlet valve solenoids.
Guide for testing the pressure switch continuity at different water levels.
Procedures for testing door lock solenoids and door switch continuity.
Guide for measuring the resistance of the drain pump motor.
Testing procedure for the temperature sensor resistance at various temperatures.
Essential checks before servicing and how to enter the washer's diagnostic mode.
Comprehensive list and explanation of washer error codes and their causes.
Specific error code and troubleshooting for door lock issues.
Error indicating potential water overflow or inlet valve issues.
Error indicating loss of electrical connection to the drain pump.
Error when the Coin 2 sensor is detected as blocked.
Troubleshooting steps for temperature sensor out-of-range errors.
Troubleshooting communication errors between CCU and MCU.
Error when a load is detected during the washer clean-out cycle.
Error indicating no communication from the debit card reader.
Error related to the motor speed detection and related troubleshooting.
Error code for the door failing to unlock after multiple attempts.
Troubleshooting communication errors between CCU and User Interface.
Troubleshooting for errors indicating an open door switch circuit.
Error indicating the motor's heat sink has exceeded its operating temperature.
Error indicating a communication issue within the User Interface.
Error when the Coin 1 sensor is detected as blocked.
Error indicating low incoming voltage to the washer.
Guide to diagnosing and resolving common washer issues like power, touch pad, and starting problems.
Solutions for problems such as overfilling, drum rotation, motor overheating, and draining.
Addresses issues like washer vibration, incorrect water temperature, and water leaks.
The complete electrical wiring diagram for the Maytag washer.
To Next Page