Why does my Maytag BRAVOS XL Dryer make a humming or whining noise during the Steam cycle?
The humming or whining noise during the Steam cycle is usually due to the water inlet valve on the dryer running. This is normal, especially if the dryer has just been installed or hasn't been used for a while. The valve may be louder and run longer under these circumstances. This noise can occur even if no water line is connected.
What to do if my Maytag BRAVOS XL Dryer won't start?
If your dryer isn't starting, make sure the door is fully closed. Press and hold the START/PAUSE button for 2–5 seconds. Check your household fuses or circuit breakers, as electric dryers often use two. Replace any blown fuses or reset tripped breakers. If issues persist, consult an electrician to ensure you have a 240-volt power supply. Also, ensure you are using a time-delay fuse.
What to do if my Maytag BRAVOS XL Dryer is not heating up?
If your dryer's drum is turning but not heating, first check your household fuses or circuit breakers; electric dryers use two. Replace any blown fuses or reset tripped breakers and if the problem continues, call an electrician. Ensure your electric dryer has a 240-volt power supply by consulting a qualified electrician. For gas dryers, verify the gas supply line valve is open.
What to do if my Maytag Washer is not draining/ spinning, and loads are still wet?
If your Maytag washer isn't draining or spinning, and your loads are still wet, it could be due to using cycles with lower spin speeds, which remove less water. Use the recommended cycle/speed spin for your garment. Also, tightly packed or unbalanced loads may prevent correct spinning. Arrange the wet load evenly for balanced spinning and select RINSE/DRAIN & SPIN to remove excess water. Check the plumbing for correct drain hose installation, ensuring it doesn't extend into the standpipe farther than 4.5" (114 mm), and remove any clogs from the drain hose. Suds from regular detergent or using too much detergent can also slow or stop draining or spinning, so use only HE detergent and follow the detergent directions for your load. To remove extra suds, select RINSE/DRAIN & SPIN, and do not a...
What causes stains on clothes from Maytag BRAVOS XL?
Stains on clothes after drying are often due to improper use of fabric softener. Add dryer fabric softener sheets at the beginning of the cycle. Adding them to a partially dried load can cause stains. Also, avoid using fabric softener sheets with Steam Cycles.
Why are my wash or rinse temperatures incorrect or wrong in my Maytag Washer?
Incorrect wash or rinse temperatures in your Maytag Washer can be due to several reasons. Check for proper water supply, ensure that the hot and cold inlet hoses are not reversed, and verify that both hoses are attached to both the washer and faucet with hot and cold water flowing to the inlet valve. Also, make sure that the inlet valve screens are not clogged and that there are no kinks in the hoses.
What does “PF” mean on my Maytag BRAVOS XL?
The “PF” code on your dryer indicates that the drying cycle was interrupted by a power failure. To resume the cycle, press and hold START/PAUSE. Alternatively, press POWER to select a new cycle.
Why does my Maytag Dryer have stains on clothes?
Stains on clothes can result from improper use of fabric softener. Add dryer fabric softener sheets at the beginning of the cycle, and avoid using them with Steam Cycles. Adding fabric softener sheets to a partially dried load can cause stains.
Why is my Maytag Washer making clicking or metallic noises?
Clicking or metallic noises in your Maytag Washer may be due to objects caught in the washer drain system. Empty pockets before washing, as loose items like coins could fall between the basket and tub or block the pump. It may be necessary to call for service to remove these items. It's also normal to hear metal items on clothing, such as metal snaps, buckles, or zippers, touch against the stainless steel basket.
Why does my Maytag Dryer have lint on clothes?
Lint on your clothes after drying is often due to a clogged lint screen. Make sure to clean the lint screen before every load.
Essential step to clean the dryer's lint screen before operation.
Properly load laundry into the high-efficiency dryer drum.
Activate the dryer by pressing the power button.
Choose the appropriate drying cycle based on the laundry load.
Customize cycle time, temperature, and dryness level.
Add extra features like steam or static reduce.
Initiate the drying process by holding the start/pause button.
General| Brand | Maytag |
|---|---|
| Model | BRAVOS XL |
| Drum Material | Stainless Steel |
| Moisture Sensor | Yes |
| Wrinkle Control Option | Yes |
| Type | Dryer |
| Color | White |
| Weight | 120 lb |
| Dryer Venting | 4-way |
| Number of Cycles | 11 |
To Next Page
