EasyManua.ls Logo

Maytag CCG2420 - Page 32

Maytag CCG2420
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Right Side
Only surface burners
may
be used on the
right side. Use the right surface burners on
HI
for
large quantity cooking and canning
because the BTU rate is higher. Also use the
right surface burners
on
LO
for
sauces and
delicate items because the
LO
setting has a
lower
BTU rate. Note CVG4380 Models: The
center bay is also designated
for
surface
burners only.
Drain
Jar
A drain
jar
is located
below
the grill basin
pan under
the
countertop. Unscrew and
remove. If
jar
is broken, replace
with
any
heat tempered jar, such
as
a canning jar,
which has a standard
screw
neck.
Filter
Turn
off
ventilation system before removing.
The filter is a permanent type.
Important:
DO
NOT
OPERATE
SYSTEM
WITHOUT
FILTER.
Filter should always be
placed at
an
angle. As
you
face the
front
of
the cooktop, the
top
of
the filter should rest
against the left side
of
the vent opening and
the
bottom
of
the filter should rest against
the right side
of
the ventilation chamber at
the bottom. If filter is flat against the fan
wall, ventilation effectiveness is reduced.
Surface Burner Heads (Sealed Burner)
The surface burner heads are removable.
The cap portion
of
the head is porcelain and
the
port
area is aluminum. Wash the burner
heads in the sink with mild detergent and a
plastic scrubber.
Check
to
be sure all ports are open.
To
open
clogged ports, insert a straight pin directly
into each port. Do
not
enlarge
or
distort
the
port.
When replacing the burner heads, carefully
align the tab on the burner base
with
the
indentation in the head. The
two
pins will
fit
in
the
slots when the tab is aligned
with
the
indentation.
Note: When burner heads are removed
for
cleaning,
do
not
spill liquids
through
the
holes in the burner base.
BURNER
HEAD
BURNER
BASE
.Surface Burner Grates
When replacing the grates, carefully align the
tab on the grate
with
the indentation in the
porcelain burner base. If the grates are
not
properly aligned,
they
may
rock.
I
BURNER
GRATE
IE'
n
d\~
I ,..
"""'ER
CAP
I
'F
DETENr
PORTS
~
tt
•••
••
i~~8URNER
HEAD
• ,
••••
1 I
IGNRER
I
INDENTATION
~:i:::
•.
16010242 Section
2.
General General
COmponent
Access
©2000
Maytag
Appliances
Sales
Company
2-2
www.Appliantology.org