Maytag MDB4949SDM0 User Manual

sanitize
©
contro| lock
hold 3 sec
Sanitizes dishes and glassware by raising water
temperature in final rinse. In accordance with NSF/ANSI
Standard 184 for Residential Dishwashers. Certified
residential dishwashers are not intended for licensed food
establishments. This option will add heat and time to cycle.
At end of the cycle, the sanitized indicator (or word
"sanitized" on some models) will glow. If your load did not
properly sanitize, the indicator will flash at the end of the
cycle. This can happen if cycle is interrupted, or if the water
does not reach the required temperature. The light goes off
when you open and close the door or press CANCEL.
Auto Increased main :04 to 1:15 0 - 3.0
PowerBlastT- wash temperature (0 - 11.2)
Normal from 105°F (41°C)
to 145°F (63°C)
and final rinse
from 140°F (60°C)
to 156°F (69°0).
O
............... i
J
start
resume
Press to start
or resume a
wash cycle
If the door is opened during a cycle or power is interrupted, Start/Resume indicator flashes. Cycle will
not resume until door is closed and Start/Resume is pressed.
NOTE: If START/RESUME button is located on top of door, push door firmly closed within 4 seconds
of pressing START/RESUME. If door is not closed within 4 seconds, start button LED will flash, an
audible tone will be heard (on some top control models), and cycle will not start.
sanitize
o
control lock
hold 3 sec
Control Lock
avoids
unintended
use of
dishwasher
between
cycles, or
cycle and
option
changes
during a cycle.
To turn on Lock, press and hold CONTROL LOCK or SANITIZE (depending on model) for 3 seconds.
Control Lock light will stay on for a short time, indicating that it is activated and all buttons are
disabled. If you press any button while your dishwasher is locked, light flashes 3 times. Dishwasher
door can still be opened/closed while controls are locked.
To turn off Lock, press and hold CONTROL LOCK or SANITIZE (depending on model) for 3 seconds.
Light turns off.
NOTE: If your model requires you to press and hold SANITIZE to lock controls, Control Locked
LED(C) will be on or off to indicate whether Control Lock is active or not.

Maytag MDB4949SDM0 Specifications

General

Style	built-in dishwashers
Color	monochromatic stainless steel, stainless steel
Cycle Selections	powerblast, auto, normal, quick, rinse
Options/Settings	heated dry, hi temp wash, sani rinse®, control lock, 1-24 hour delay
Delay Start	yes
Number of Racks	2
Cycle Signal	yes
Water Filter	yes
Food Disposer	yes
Sanitize Settings	no
Annual Energy Consumption	270 kilowatt hours
Voltage	120 volts
Current	15 amperes

Weight and Dimensions

Depth	25.2 inches