INSTALLATIONREQUIREMENTS
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
All Installations
Tools needed:
Pers Flat-blade
• screwdriver
5/%. and 1/4" _ _tedlCSA --
nut drivers or _._ Approved twist-on _ 8
hex sockets _ wire connectors*
10 adjustab e wrench %" n n
" " h _ ope -e d
that opens to _JT"_" wrn^h --/CJ"
1 _ L,
1Y8' (2 9 cm) _,
*Must be the proper size to connect your household winng
to 16-gauge wiring in dishwasher.
Other useful items you may need:
Shallow Bath
pa towel -_" J
Parts supplied:
Drain hose Drain #10 xlW' Undercounter
clamps (2) hose Phillips-head mounting
(1 large and screws (2) brackets (2)
1 small)
Make sure all these parts are included in the literature package.
t®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.
Parts needed:
[/8,c_mpression x-------3/4,,hose fitting
For part or kitl see local retailer
3r CallWhirlpool Parts:
t-800.442-9991 Part Number
Other parts you may also need:
I !1/2"-2' I Masking or Moisture
(3,8!-5 cm) I duct tape bardertape f_!
Sc[ew4ype .... I I(Part Number Jj/ I
damps (3 maximum) 4396277) _!
NOTE: Parts available for purchase in plumbing supply stores.
Check local codes. Check existing electrical supply. See
"Electrical Requirements" section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Tools needed:
Cordless drill (
With 1/2is/4''
1 _
and 1V2 hole
Saw bits
Parts needed:
Copper tubing (3/8" see "EleCtrical Requirements-section,
O.D.suggested)0r i ., : i ,, ,, ,
flexible braidecl For L)irect wire: For _-ower bupply
w I lin use UL Listed/ Cord" use UL
ater supp y e
CSA Approved Listed/CSA
I strain relief I Approved power
_ttLkkk _)_))));) I t° fit 7W'(2"2 cm) Supply C0rd kit
hole marked for use with
diShWasher
To Next Page
Loading...
Need help?
General
