Maytag MEDB855DC - User Manual

Questions and Answers

V
Valerie BellAug 21, 2025
Why are my clothes not drying in my Maytag MEDB855DC?
- M
  Madison ThomasAug 21, 2025
  If clothes are not drying well or drying times are too long in your Maytag Dryer, first, clean the lint screen before each load and the area where the lint screen is located, removing any accumulated lint with a vacuum. Next, check the exhaust vent and outside exhaust hood for clogs; run the dryer on Air Only for 5–10 minutes and feel for air movement at the hood. Clean the exhaust system or replace the vent with a heavy metal or flexible metal vent if needed. Also, ensure the exhaust vent isn't too long, doesn't have too many turns, and is the correct 4" (102 mm) diameter. Finally, make sure the dryer is level, and you've selected the right temperature setting for your garments.
N
Nicholas JohnsonAug 25, 2025
Why is my Maytag Dryer making a rattling noise?
- C
  Carl HamiltonAug 25, 2025
  If your Maytag Dryer is making a rattling or vibrating noise, check the front and rear edges of the drum for small objects. Also, ensure the dryer is properly leveled with all four feet firmly on the floor. If clothing is balled up, separate the items and restart the dryer.
A
Andrew YoungAug 26, 2025
Why is my Maytag MEDB855DC not heating up?
- D
  David RomeroAug 26, 2025
  If your Maytag dryer isn't heating, the drum may still be turning, but there could be an issue with the heat. Check your household fuses or circuit breakers, as electric dryers use two. Replace any blown fuses or reset tripped breakers. If the issue continues, contact an electrician to ensure your electric dryer has a 240-volt or 208-volt power supply. For gas dryers, verify that the valve on the gas supply line is open.
R
Richard WestAug 27, 2025
Why is there lint on my clothes after using my Maytag Dryer?
- C
  cmunozAug 28, 2025
  If lint appears on your clothes after drying in your Maytag Dryer, it is likely because the lint screen is clogged. Make sure to clean the lint screen before each load.
R
Richard LopezAug 30, 2025
Why is my laundry load too hot after using my Maytag MEDB855DC Dryer?
- T
  Troy LeeAug 30, 2025
  If your Maytag Dryer load is too hot, allow the dryer to complete the cool-down portion of the cycle before removing the load. If you're using a Timed Dry cycle with a high temperature setting, switch to a Sensor Cycle with a lower heat setting to prevent overdrying.
E
Ebony WilcoxSep 1, 2025
Why does the “Check Vent” light come on my Maytag MEDB855DC Dryer?
- D
  dbookerSep 1, 2025
  If your Maytag Dryer displays the “Check Vent” cycle status indicator, it means the vent is clogged, crushed, kinked, or has too many turns, leading to a blocked vent or low airflow. To resolve this: * Clean the lint screen. * Check the vent run from the dryer to the wall for crushing or kinking. * Ensure the vent run is free of lint and debris. * Confirm the exterior vent exhaust hood is clear of lint and debris. * Verify your vent system is within the recommended run length and number of elbows. If the message persists, have your entire home venting run cleaned by a venting specialist.
K
Kevin WoodwardSep 3, 2025
What does “F# E#” mean on my Maytag MEDB855DC?
- R
  Renee Lara DDSSep 3, 2025
  If your Maytag Dryer displays an “F# E#” code (like F1 E1, F3 E1), it means the dryer has detected a problem requiring professional service. Call for service to address the issue.
S
Steven VelazquezSep 5, 2025
Why is the cycle time too short on my Maytag Dryer?
- S
  Sherry RyanSep 5, 2025
  If your Maytag dryer cycle time is too short, it might be because the load isn't contacting the sensor strips properly during Sensor Cycles. Make sure the dryer is level, with all four feet firmly on the floor. If you're using the Steam Refresh cycle for one or two items, add a towel to help avoid uneven spraying. Adjust the dryness level setting on Sensor Cycles; increasing or decreasing the dryness level will change the cycle's drying time. If loads consistently end too early, you may also need to adjust the Sensor Cycle settings to increase drying time.
B
briantaylorSep 7, 2025
Why are there stains on my clothes after using my Maytag Dryer?
- S
  Sharon CallahanSep 8, 2025
  If you find stains on your clothes after using your Maytag Dryer, it could be due to improper use of fabric softener. Add dryer fabric softener sheets at the beginning of the cycle, as adding them to a partially dried load can cause stains. Also, avoid using fabric softener sheets with steam cycles.
H
Hannah MclaughlinSep 9, 2025
What does “PF” mean on my Maytag MEDB855DC display?
- J
  Jennifer MaciasSep 10, 2025
  If your Maytag Dryer displays “PF” (power failure), it means the drying cycle was interrupted by a power outage. Touch the START key to clear the message, then press and hold START to resume the cycle.

Summary

Dryer Safety

Safety Alert Symbols and Definitions

Explains DANGER and WARNING symbols and their meanings for potential hazards.

Fire Hazard Warning

Warns about fire risk due to improper venting materials and installation.

Important Safety Instructions

General Safety Precautions

Lists essential precautions to prevent fire, electric shock, or injury when using the dryer.

Gas Leak Safety Procedures

Provides critical steps to take in case of a gas leak and installation requirements.

California Proposition 65 Warnings

Details chemicals in the product known to cause cancer or reproductive harm in California.

Check Your Vent System for Good Air Flow

Importance of Airflow and Venting

Explains how good airflow is crucial for dryer efficiency and lists actions to maintain it.

Energy Saver Feature

Describes the Energy Saver option, which uses lower heat and extends cycle time for savings.

Sensor Cycles Benefits

Highlights how Sensor Cycles optimize energy savings and fabric care by sensing moisture.

Steam Dryer Performance Tips

Offers advice for optimal performance when using steam dryer features.

Control Panel and Features

Control Panel Overview

Details the buttons, knobs, and displays on the control panel for operating the dryer.

Options

Dryer Operation Options

Explains available options like Energy Saver, Static Reduce, Damp Dry Signal, and Audio Level.

Cycle Status Indicators

Describes the meaning of various indicator lights like Sensing, Check Vent, Done, and Check Lint Screen.

Cycle Guide - Sensor Cycles

Sensor Cycle Descriptions

Details various sensor cycles, their temperatures, dry levels, available options, and specific usage.

Load Size Recommendations

Provides guidance on optimal load sizes for best drying results.

Cycle Guide

Timed Cycles Guide

Explains Timed Dry and Rapid Dry cycles, time adjustment, temperature selection, and load size guidance.

Steam Cycles Guide

Details the Steam Refresh cycle for reducing wrinkles and odors, including load size recommendations.

Using Your Dryer

Step-by-Step Operation

Guides users through cleaning the lint screen, loading, and starting the dryer.

Selecting Cycles and Options

Cycle and Option Selection

Details how to select cycles, adjust settings like temperature and dry level, and choose additional options.

Starting and Finishing the Cycle

Explains how to start the dryer, use Wrinkle Prevent, and the importance of prompt removal of garments.

Additional Features and Settings

Adjusting Sensor Cycle Settings

Guides users on how to customize default dryness levels for Sensor Cycles.

Using the Drying Rack

Details how to use the drying rack for items that should not be tumbled, including cycle selection.

Dryer Care and Cleaning

Lint Screen Cleaning

Provides detailed instructions for cleaning the lint screen before/after each load and for deep cleaning.

Dryer Interior and Lint Removal

Explains how to clean the dryer drum, interior, and remove accumulated lint from cabinet and exhaust.

Non-Use, Storage, and Moving Care

Storage and Non-Use Precautions

Advises on how to care for the dryer when not in use or during storage.

Moving Care Instructions

Details steps for safely moving the dryer, including power and gas/water disconnection.

Special Instructions for Steam Models

Steam Model Water Hose and Winterization

Covers steam model hose replacement, winterization, and re-use procedures.

Troubleshooting

Dryer Operation and Noise Issues

Addresses common problems like the dryer not running, heating, or making unusual noises.

Drying Performance Issues

Solves issues related to clothes not drying properly or taking too long, including vent and sensor strip checks.

Additional Troubleshooting

Drying Performance and Appearance Issues

Resolves problems with drying time, lint, stains, wrinkles, odors, and steam function.

Dryer Codes and Service Troubleshooting

Load Temperature and Display Indicators

Addresses issues like loads being too hot and explains various dryer display codes and indicators.

Troubleshooting Service Codes

Explains variable service codes (F# E#) and advises when to call for service.

Limited Warranty

Warranty Coverage and Exclusions

Details what is covered and not covered under the Maytag limited warranty, including disclaimers.

Obtaining Warranty Service

Provides instructions on how to get service, contact information, and required proof of purchase.

Maytag MEDB855DC Specifications

General

Brand	Maytag
Model Number	MEDB855DC
Type	Electric Dryer
Energy Star Certified	No
Steam Cycle	Yes
Steam Refresh Cycle	Yes
Wrinkle Prevent Option	Yes
Sensor Drying	Yes
Drum Material	Stainless Steel
Moisture Sensor	Yes
Weight	120 lb