IN$ LATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Parts supplied (all models):
Flat-blade screwdriver
#2 Phillips screwdriver
Leveling legs (4)
Parts supplied {steam models):
Wire stripper (direct wire
installations)
1/4" nut driver
(recommended)
Tin snips (new vent
installations)
Vent clamps
&
"Y" connector
Long inlet hose
Short inlet hose
Rubber washer
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife
Tape measure
Pliers
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: If installing dryer on pedestal, do not use leveling legs.
Optional Equipment: (Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Level
G )=-
Caulking gun and
compound (for installing
new exhaust vent)
To Next Page
Loading...
Need help?
General