Maytag MER5875QCS User Manual

INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE
INSTALLATION MANUAL
Electric 30-inch Wide
Free-standing Range
PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE
THE MANUAL IS INTENDED TO ASSIST IN THE INITIAL INSTALLATION AND ADJUSTMENTS OF THE RANGE.
SPECIAL WARNING
Only qualified personnel should
install or service this range.
Read “Safety Instructions” in Use &
Care book before using range.
Improper installation, adjustment,
alteration, service, maintenance or
use of range can result in serious
injury or property damage.
CLEARANCE DIMENSIONS
For complete information in regard to installation of
freestanding range, see figures 1 and 2 on page 2. For
SAFETY CONSIDERATIONS do not install a range in
any combustible cabinetry which is not in accord with the
installation clearances shown in figure 1.
MOBILE HOMES
The installation of a range designed for mobile home
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24 HUD, Part 280) or,
when such standard is not applicable, the Standard for
Manufactured Home Installations 1982 (Manufactured
Home Sites, Communities and Set-Ups), ANSI
A225.1-latest edition, or with local codes.
LOCATING THE RANGE
Place range in a well lit area. Do not set range over
holes in the floor or other locations where it may be
subject to strong drafts. Any opening in the wall behind
the range and in the floor under the range should be
sealed. Make sure the flow of cooling/ventilation air is
not obstructed below the range.
CAUTION: This range has been designed in
accordance with the requirements of various safety
agencies and complies with the maximum allowable
wood cabinet temperatures of 194°F. If this range is
installed with cabinets that have a lower working
temperature than 194°F, discoloration, delamination
or melting may occur.
8101P506-60
(08-03-01)
Your range may not be equipped with some of the features referred to in this
manual.
ENGLISH '
''
' PP. 1-7
ESPAÑOL '
''
' pág. 8-14
FRANÇAIS '
''
' p. 15-21

Maytag MER5875QCS Specifications

General

Brand	Maytag
Model	MER5875QCS
Category	Ranges
Language	English

Summary

Special Warning and Safety Precautions

Clearance Dimensions

Mobile Homes Installation Requirements

Range Location Guidelines

Installation Drawings and Diagrams

Anti-Tip Device Installation Instructions

Step 1: Locating the Anti-Tip Bracket

Determine bracket placement on floor or wall, mark holes, and use as a template for installation.

Step 2: Anti-Tip Bracket Installation Options

Instructions for securing the bracket to wood or cement/concrete construction using provided screws.

Step 3: Range Installation with Anti-Tip Device

Level range, connect power, slide into place, and verify anti-tip bracket engagement.

Connecting the Range Electrical Supply

Electric Supply Requirements

Adhere to Local and National Electric Codes (NEC) for installation.

Electric Supply (Canada)

Follow Canadian electric codes (CSA STD.C22.1) for installation.

Outside Wiring Considerations

Consult local utility for service adequacy and potential wiring upgrades.

House Wiring Standards

Use licensed electricians and comply with codes for single-phase AC circuits.

Range Connections (General)

Use appropriate service cords (4-conductor recommended) and ensure secure connections.

Range Connections (Canada)

Models with factory-attached cords require simple plug-in connection.

Wiring Service Configurations

3-Wire Service Cord or Conduit Installation

Detailed steps for connecting a 3-wire service cord or conduit, including ground strap and torque specifications.

4-Wire Service and Conversions

4-Wire Service Cord or Conduit Installation

Instructions for 4-wire connection, including ground strap modification and torque specs.

Conversion From 3-Wire To 4-Wire Service

Steps to disconnect 3-wire cord and connect a 4-wire cord for mobile homes or specific codes.