Need help?Do you have a question about the Maytag MFR40 and is the answer not in the manual?
General safety precautions and warnings for operating the Maytag commercial washer.
Explains the meaning of various buttons and symbols used in the manual.
Describes the function of the service key for switching between operational modes.
Overview of the MCG wash computer's features, display information, and hardware.
Details on accessing and navigating the Service and Set-up modes for machine configuration.
Explanation of how wash programs are structured with sequences and programmable functions.
Explains the importance of programming values within specified operational limits.
Details on programming water temperature, including minimum and maximum values.
Explains water level programming options and recommended levels for different cycles.
Setup options for extraction speed limits and soap supply signals.
Overview of settings for coin selection and debit card reader in the Pricing Menu.
Details on special pricing functions and the use of the machine's clock for timed pricing.
Settings for temperature-based and upgrade-based pricing within the Enhanced Pricing menu.
Instructions on how to access and navigate the Initialization Menu for basic settings.
Details on the Configuration Menu, its importance, and access methods for machine-specific parameters.
Guide on accessing and selecting wash cycles within the Wash Cycle Menu for programming.
Step-by-step guide for starting up, operating, and managing wash cycles.
Information about various messages that may appear on the display during operation.
Procedures for handling fault messages and specific error conditions encountered.
A comprehensive overview of diagnostic messages, their failures, and actions.
Lists the functions and information available within the Service Menu for technical support.
Explains the purpose and access method for the diagnostic program and various tests.
A list of common problems, their causes, and suggested solutions for troubleshooting.
Detailed explanations for specific diagnostic codes, help codes, and error codes.
Instructions for routine maintenance and information required for service inquiries.
Diagram and step-by-step instructions for replacing the programmer circuit board.
Procedures for installing new software onto the wash computer.
Details specifications of the machine including data, electronic, configuration, and initialization parameters.
To Next Page
General
