516532 B PUBLICATION DATE 1 JUN 2007.DOC PROGRAMMING MANUAL 57
HELP CODE E95 : WATCH DOG
If the watch dog has been activated, Help Code H53 is logged in the Error log register. If this occurs often,
ask the help of a technician.
DIAGNOSTIC CODE D12
ERROR CODES 300-353: MITSUBISHI INVERTER ALARM MESSAGE
If a Mitsubishi Inverter Alarm occurs, check the trouble shooting in the Mitsubishi inverter manual.
300 Err OC1 308 Err FAN 316 Err RET 324 Err OP2 332 Err MB5 340 Err E.3 348 USB
301 Err OC2 309 Err OLT 317 Err CPU 325 Err OP3 333 Err MB6 341 Err ILF 349 OS
302 Err OC3 310 Err BE 318 Err E.6 326 Err CTE 334 Err MB7 342 Err PTC 350 OD
303 Err OV1 311 Err GF 319 Err E.7 327 Err P24 335 Err FIN 343 Err PE2 351 EP
304 Err OV2 312 Err OHT 320 Err IPF 328 Err MB1 336 Err OSD 344 Err CDO 352 E.11
305 Err OV3 313 Err OPT 321 Err UVT 329 Err MB2 337 Err ECT 345 Err IOH 353 E.13
306 Err THT 314 Err PE 322 Err LF 330 Err MB3 338 Err E.1 346 Err SER
307 Err THM 315 Err PUE 323 Err OP1 331 Err MB4 339 Err E.2 347 Err AIE
DIAGNOSE FOR FAILURE 303-304-305 (OV-ERRORS) :
1. Check if the correct machine type is
selected in the S-submenu
If the wrong machine type is selected, enter the right
machine type
2. Check if there was a high unbalance during
extraction, which can be caused by putting
only half loads in the machine.
Put always a full load in the machine drum.
Do not put other material than textile linen (fabrics) in
the machine.
3. Check if the fault is persistent If the fault is persistent, contact the manufacturer
DIAGNOSTIC CODE D18
ERROR CODES 500-518: MEMORY ERRORS
If a memory error occurs then something is going wrong with the EPROM.
Try to reload the Programs. Check for source of electrical „noise“.
DIAGNOSTIC CODE D19
ERROR CODES 600-630: SOFTWARE ERRORS
Software errors must never occur. If a software error message occurs inform the manufacturer.
To Next Page
Loading...
