Storing the Refrigerator .....................................
Vacations
If you will be gone for a month or less, leave the controls
at the usual settings.
During longer absences:
a) remove all food,
Moving
When moving, follow steps a--d under Vacations. In
addition, remove and carefully pack any items that are
easily removable. Ship the refrigerator in an uptight
position with the doors taped shut.
b) shut off the ice maker (if installed) and the valve
where you tapped into the water line to supply the
refrigerator,
c) disconnect the refrigerator from the electrical outlet,
d) clean and dry the refrigerator thoroughly,
e) leave the doors open to prevent odors.
Care and Cleaning ...............................................
Refer to the chart on the following page for specific
refrigerator cleaning guidelines.
Disconnect the power cord before
cleaning.
Cleaning Under the Refrigerator
Your refrigerator can be rolled out for cleaning the floor
underneath. Raise the locking feet if engaged (see page
3). Pull the refrigerator straight out from the wall.
No Clean TM commercial-duty
Condenser
A clean condenser means more efficient refrigerator
operation. Thanks to the unique design of the No
Clean TM condenser there's no longer a need for routine
condenser cleaning in normal home usage surroundings.
Some operating environments may be particularly dusty
or greasy. In these situations, the condenser can be peri-
odically cleaned to insure maximum efficiency.
Replacing a Light Bulb
_k CAM//OJ_ Disconnect the power cord before replacing light bulb(s). Wear gloves
as protection against possible broken glass.
Always use a standard 40 or 60 watt appliance bulb.
Refrigerator
There are two light bulbs located under the top of the
refrigerator compartment, on either side of the Dual
Cool TM control housing.
• Carefully grasp the lighthulb by reaching behind the
bulb cover.
• Unscrew the light bulb and replace.
Freezer
The freezer light is located on the back wall, near the
upper right comer.
To remove the bulb cover:
• Grasp the top and bottom of the bulb cover. Press in
the areas of the attachment tabs, applying enough
pressure to unhook the tabs. At the same time, pivot
the cover down and remove.
• Unscrew the lightbulb and replace.
• Replace the bulb cover by pivoting it back into place
and snapping the tabs into the appropriate slots.
13
To Next Page
Loading...
