9
COMPLETE INSTALLATION
CHECKLIST
Check electrical requirements. Be sure you have correct ■
electrical supply and recommended grounding method.
See “Electrical Requirements”.
Check that all parts are now installed. If there is an extra ■
part, go back through steps to see what was skipped.
Check that you have all of your tools. ■
Keep the foam packing ring from the washer tub for future ■
relocation of the washer. Dispose of/recycle all packaging
materials.
Check that both water faucets are on. ■
Check for leaks around faucets and inlet hoses. ■
Remove lm from console and any tape remaining ■
on washer.
Check that washer is plugged into a grounded ■
3 prong outlet.
Read “Washer Use” in your “Use and Care Guide”. ■
To test and clean your washer, measure 1/2 of normal ■
recommended amount of High Efciency (HE) powdered
or liquid detergent for a medium-size load and pour it into
detergent dispenser. Close lid. Press POWER. Select
a normal cycle and press Start. Allow it to complete
one whole cycle.
To Next Page
Loading...
Need help?
General