7. Select wash temperature
temperature
all c0[d rinses
cold
9. Press START/Pause/Unlock to begin
wash cycle
start
pause/unlock
hold3sec,
to cancel
Once you select a cycle, select the desire wash temperature by
turning the Temperature knob to the desired setting.
Always read and follow fabric care [abe[ instructions to avoid
damage to your garments.
iii.or iii
::iSome cold water is added to save Whites and pastels
::ienergy. This will be cooler than Durable
garments
your hot water heater setting. , .,
:: , Heavy so s
Wa,m :::
ii
Some cold water will be added, so Bright colors
this will be cooler than what your Moderate to light soils
previous washer provided.
Co o I
Warm water is added to assist in ::i Colors that bleed
soil removal and to help dissolve : or fade
detergents. Light soils
Cold
ii
Warm water may be added to assist Dark colors that
:i in soil removal and to help dissolve bleed or fade
: detergents.
Press the START/Pause/Unlock button to start the wash cycle.
Filling is delayed for several minutes while load balance is
sensed. When the cycle has finished, the DONE indicator will
light. Promptly remove garments after cycle has completed
to avoid odor, reduce wrinkling, and rusting of metal hooks,
zippers, and snaps.
Unlocking the lld to add garments
If you needto open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock; the lid will unlock once the washer
movement has stopped. This may take several minutes if the
load was spinning at high speed. Then close lid and press
START/Pause/Unlock again to restart the cycle.
If lid is left open for more than 1 0 minutes the water will pump
out automatically.
DeLay in water fill
Filling is delayed for 2 to 3 minutes to check for load unbalance.
You will hear the hum of the spin prior to filling. This is normal
operation.
8. Select cycle options, if desired
deep dean extra rinse
off on off on
If you would like to add a Deep Clean and/or Extra Rinse
option, turn the knob for that feature to ON.
To Next Page
Loading...
Need help?
General
