L' RMA AG
Installation
Instructions
Top Loading Washer
Keep instructions for future reference.
Be sure manual stays with washer.
Instructions d'installation ........................ Page 7
Instructions de Instalaci6n ..................... Page 13
f
You'll Need a Few Things Before You Begin:
Tools
Screwdriver _L-/_,
Priers
Parts Supplied
2 water fill
hoses
4 rubber leveling @,@
footpads @@
Wrench
Level
7
2 screened
hose filters
2 flat
rubber washers
beaded tie-down
strap __
f
MOVE WASHER TO
FINAL AREA;
REMOVE SHIPPING
BRACE & PLUG
Protect the floor when moving the
washer. Washer must be within 4' of
desired area before beginning
installation. Open washer lid and
remove installation parts from ship-
ping brace for use.
Reach through foam shipping
brace, grasp bottom of brace,
and pull up to remove.
NOTE: Save shipping plug and
shipping brace; reinstall whenev-
er washer is moved more than 4'.
Do not lift or move washer without
shipping materials in place.
To remove the shipping plug from
the washer, step on the card board
base, tilt the washer back, and slide
out the base.
Cardboard
base
Part No. 40136001
Printed in U.S.A. 11/01
Shipping
brace
Shipping
plug
J
J
To Next Page
Need help?
General