99996212-LSWIF
O Robotoperation
Set Up
2
Attach the floating cable to the power supply.
@ Maintenance
Periodic filter cleaning
Dismantle the 4 filter panels of the outer basket according to the following steps:
Into the pool
Operation
Ilcm/4"
3.5m/12ft
Position the power supply at least
3.5m /12ft away from the edge of the pool.
Out of the pool
Put the Pool
Cleaner into
the pool.
Release the Pool
Cleaner and let it
sink to the floor
of the pool.
Make sure that
the floating cable
is free of any
obstructions.
O Cleaning thefilter
Turn the power supply ON.
The pool cleaner will now
operate until it has reached
the end of the cleaning cycle.
It is highly reccomended to clean the filter basket after each cleaning cycle.
Note: Don't let the filter cartridges dry out before cleaning.
Unplug the power supply before servicing
click!
Open the latch to
release the bottom lid
in order to remove the
debris.
Clean the filter basket
with a hose.
Dismantle the panels,
starting with pressing on
panel no.l using your thumbs.
Cleaning the impeller
If you notice debris trapped in the impeller:
Unplug the power supply before servicing
Clean the debris trapped in the impeller opening,
according to the following steps:
Oil
Continue to dismantle the panels
in the order of their numbers: no.2--> no.3--> no. 4.
click!
click!
h,
Open the filter cover.
Storage
Lift up the basket.
For a detailed manual (including videos):
maytrnnics
olp in
Coil the cable and store in a cool, dry place.
Do NOTstore the robot and its accessories where it will be exposed to direct sunlight, excessive heat or frost.
manuals.maytronics.com/en/ gggg6212-LSWlF
To Next Page
Loading...
