Black plate (264,1)
qClock
When the ignition switch is in the ACC or
ON position, the time is displayed.
Without navigat ion system
Time settin g
1. Press the CLOCK switch until a beep
sounds, and “12Hr” and “24Hr” will be
displayed.
2. Press the SET switch to switch between
“12Hr” and “24Hr” displays. The
selected display will flas h.
To select the desired clock setting,
press the CLOCK switch again while
the preferred setting is flashing.
3. “Hr. ADJUST” will be displayed next,
and the hour portion of the display will
flash. Press the SET switch to set the
hour, then press the CLOCK switch.
4. “Min. ADJUST” will be displayed
next, and the minutes portion of the
display will flash. Press the SET switch
to set the minutes, then press the
CLOCK switch.
Time resetting
While the clock is displayed, press the
SET switch 1.5 seconds or more. When
the switch is released, a beep will sound
and the clock will be reset as follows:
(Example)
12:01―12:29→12:00
12:30―12:59→1:00
NOTE
When the SET switch is released, the seconds
are reset to “00” .
With navigation system
Refer to “NAVIGATION SYSTEM”.
NOTE
Minutes and seconds are adjusted by the GPS,
however, it is necessary to adjust hours under
the following conditions:
l
Driving across different time zones
l
Daylight saving time start and end
qAmbient Temperature Display
(Fully Automatic Type)
When the ignition switch is in the ON
position, press the AMB switch to display
the ambient temperature.
6-50
Interior Comfort
Interior Equipment
CX-7_8X59-EA-07E_Edition3 Page264
Wednesday, July 25 2007 3:19 PM
Form No.8X59-EA-07E
To Next Page
Loading...
