Bulletin No: 09-036/14
© 2014 Mazda Motor of America, Inc.
Last Issued: 08/29/2014
Page 2 of 16
VERIFICATION PROCEDURE
1. Apply masking tape (A) to the upper
part of the front belt line molding of the
front door with the noise. [Apply mask-
ing tape to properly cover the position
shown in the red circle.(B)]
2. Test drive the vehicle at approximately
50 mph (81 km/h) on a smooth road.
Did the wind noise decrease?
a. Yes - Perform REPAIR PROCE-
DURE A.
b. No - Perform REPAIR PROCEDURE
A and B on any door with the noise.
NOTE: Condition may be difficult to duplicate under the following conditions:
• above 50 mph (81 km/h)
• rough roads
• heavy traffic
• windy conditions
REPAIR PROCEDURE A
Replace the inner weather strip and the front beltline molding.
1. Fully open the front door glass.
2. Remove the front door trim. Refer to MS3 online or Workshop Manual (section 09-17 FRONT DOOR TRIM
REMOVAL/INSTALLATION).
3. Remove the inner weather strip (A).
To Next Page
Loading...
