When pulling the tilt/slide switch
rearward 1 time, the sunshade opens
and when pressing the tilt/slide switch
forward 1 time, it closes.
Close the sunshade before operating
the panorama sunroof.
1. Open
2. Close
NOTE
If a close operation is done while the
sunshade is opening, it stops partway.
▼
Tilt/Slide Operation
The panorama sunroof can be opened
or closed electrically only when the
ignition is switched ON.
Before leaving the vehicle or washing
your Mazda, make sure the
panorama sunroof is completely
closed so that water does not get
inside the cabin area.
After washing your Mazda or after it
rains, wipe the water o the
panorama sunroof before operating
it to avoid water penetration which
could cause rust and water damage
to your headliner.
Tilt Operation
The rear of the panorama sunroof can
be tilted open to provide more
ventilation.
When pressing the tilt/slide switch 1
time, the sunshade opens a quarter of
the way and the rear side of the front
panorama sunroof glass opens
upward.
When pressing the tilt/slide switch
forward 1 time, the panorama sunroof
closes.
NOTE
The sunshade can be fully opened by
pulling the tilt/slide switch rearward 1
time with the panorama sunroof tilted.
To close the sunshade and the
panorama sunroof from this condition,
press the tilt/slide switch forward 2
times.
1. Tilt up
2. Close (Tilt down)
Before Driving
Windows
3-41
CX50_8MG7-EA23G_Edition1_new 2023-3-13 9:43:28