Mazda CX-50 2024 - Location of the Tire Label (Placard)

70
“70” is the aspect ratio. This two-digit
number indicates the tire's ratio of
height to width.
D
“D” is the tire construction symbol. D
indicates “diagonal ply construction”.
16
“16” is the wheel rim diameter in
inches.
90
“90” is the Load Index. This two-or
three-digit number indicates how
much weight each tire can support.
M
“M” is the speed rating. The speed
rating denotes the maximum speed for
which the use of the tire is rated.
Letter Rating Speed Rating
M 81 mph
Location of the Tire Label
(Placard)
▼
Location of the Tire Label (Placard)
You will find the tire label containing
tire
inflation
pressure by tire size and
other important information on the
driver's side Bpillar or on the edge of
the driver's door frame.
SAMPLE
▼
Recommended Tire Inflation
Pressure
On the tire label you will find the
recommended tire
inflation
pressure in
both kPa and psi for the tires installed
as original equipment on the vehicle. It
is very important that the
inflation
pressure of the tires on your vehicle is
maintained at the recommended
pressure. You should check the tire
pressure regularly to insure that the
proper inflation pressure is maintained.
Refer to Tires on page 9-7.
NOTE
Tire pressures listed on the vehicle
placard or tire information label
indicate the recommended cold tire
inflation pressure, measured when the
tires are cold, after the vehicle has
been parked for at least 3 hours. As
you drive, the temperature in the tire
warms up, increasing the tire pressure.
Customer Information and Reporting Safety Defects
Tire Information (U.S.A.)
8-25
CX50_8MG7-EA23G_Edition1_new 2023-3-13 9:43:28