Mazda CX-50 2024 - Page 281

▼
Setting the System
Operation conditions
Headway control function
The TJA operates when all of the following conditions are met.

The vehicle speed is about 0 km/h (0 mph) to 145 km/h (90 mph).

The selector lever is in the D or M position (manual mode).

The TJA is operating.

The headway control function of the Mazda Radar Cruise Control (MRCC) or
Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go
function) is set to operable (if it was set to inoperable, set it to operable using the
personalization function).

The brake pedal is not depressed.

The parking brake is released (Electric Parking Brake (EPB) indicator light is turned
o).

There is no problem with the DSC.

All the doors are closed.

The driver's seat belt is fastened.
NOTE

Under the following conditions, the TJA cannot be used when the vehicle speed is
30 km/h (19 mph) or slower.

There is a problem with the stop hold control function.

There is a problem with the Electric Parking Brake (EPB).

The TJA may not launch directly after the engine starts.
Steering assist function
The steering assist function operates when all of the following conditions are met.

Your vehicle is moving and less than about 56 km/h (35 mph).

White (yellow) lane lines on both sides are detected and you are driving near the
center of the lane, or your vehicle detects a vehicle ahead.

The steering wheel is not turned sharply.

The turn signal lever is not operated.

The headway control function is operating.
NOTE

The steering assist function operates so that the vehicle remains near the center of
the driving lane, however, depending on conditions such as the road curvature,
road slope and undulations, and vehicle speed, the function might not be able to
keep the vehicle near the center of the driving lane.
When Driving
i-ACTIVSENSE
4-130
CX50_8MG7-EA23G_Edition1_new 2023-3-13 9:43:28