Due to variations in the design of
child-restraint systems, vehicle seats
and seat belts, all child-restraint systems
may not fit all seating positions. Before
purchasing a child-restraint system, it
should be tested in the specific vehicle
seating position (or positions) where it
is intended to be used. If a previously
purchased child-restraint system does
not fit, you may need to purchase a
different one that will.
Baby seat
Equal to Group 0 and 0
of the UN-R 44
and UN-R 129 regulation.
Child seat
Equal to Group 1 of the UN-R 44 and
UN-R 129 regulation.
Junior seat
Equal to Group 2 and 3 of the UN-R 44
and UN-R 129 regulation.
When using a booster seat, always
install the vehicle head restraint to
the seat where the booster seat is
installed.
Booster seat
*
1
*
1
▼
Baby Seat Installation Position
A baby seat is used in the rear-facing
position only.
Refer to the table, “Child-Restraint System
Suitability for Various Seat Positions” for
baby seat installation position (page
2-46).
Essential Safety Equipment
Child Restraint
2-42
CX-8_8HJ9-EI-19E_Edition2_old 2020-4-15 13:00:04
To Next Page
Loading...
