Mazda CX-8 - Page 283

▼
Shift-up/Shift-down Request Display
The shift-up or shift-down request display in the active driving display or multi-information
display may be indicated while the MRCC is operating. When this occurs, shift gears
because the gear position is not appropriate.
Request
Indication on display
Multi-information display Active driving display
Shift up
Shift down
NOTE
If the gears are not shifted up/down even though the shift-up/down request indication is
displayed, load will be applied to the engine and the MRCC system may be automatically
cancelled or engine damage could occur.
▼
Cruise Control Function
While this function is operating, the
headway control operation is cancelled
and only the cruise control function
operates.
The vehicle speed can be set more than
about 25 km/h (16 mph).
Use the cruise control function on
expressways and other highways which do
not require a lot of repeated acceleration
and deceleration.
WARNING
Do not use the cruise control function in
the following locations:
Otherwise, it could lead to an accident.
Roads with sharp curves and where
vehicle trac is heavy and there is
insucient space between vehicles.
(Driving under these conditions using the
cruise control function is not possible)
Steep down slopes (Set speed may be
exceeded because sucient engine
braking cannot be applied)
Slippery roads such as ice or snow-bound
roads (Tyres could spin causing you to
lose vehicle control)
When Driving
i-ACTIVSENSE
4-107
CX-8_8HJ9-EI-19E_Edition2_old 2020-4-15 13:00:04