Mazda CX-9 2016 - Driving Position Memory

2 – 8
Essential Safety Equipment
Seats
*Some models.
Driving Position Memory
*
The desired driving position can be called
up after programming the position.
The following driving positions can be
programmed.
y
Driver’s seat position (seat slide, height
adjustment, seat recline)

Refer to Seat Operation on page 2-5 .
y
Active driving display (display position,
brightness level, display information)

Refer to Active Driving Display on page
4-29 .

CAUTION
Do not place  ngers or hands around
the bottom of the seat while the seat
memory function is operating. The
seat moves automatically while the
seat memory function is operating and
 ngers or hands could get pinched and
injured.
SET button
The driving position can be programmed
or operated using the buttons on the side
of the seat or the key.
N O T E
y
Individual seat positions can be
programmed to the two available
programming buttons on the side of the
driver's seat, plus one seat position for
each registered key.
y
If the vehicle has been serviced and
the battery cables disconnected, the
programmed seat positions will have
been erased. Re-program the seat
positions.
Programming
1. Make sure the parking brake is on.
2. Make sure the selector lever is in the P
position.
3. Start the engine.
4. Adjust the seat and the active driving
display to the desired driving position.
5. Press the SET button on the seat until a
beep sound is heard one time.
6. Perform one of the following settings
within 5 seconds of completing step 4
above:

y

Programming using a button on
the side of the seat

Press the button you want to program,
either button 1 or 2, until a beep
sound is heard one time.

y

Programming using the key
Press the key
button until a beep
sound is heard one time.
N O T E
If a beep sound is heard three times, the
operation is canceled.
CX-98FD6-EA-16BEdition3.indb8CX-98FD6-EA-16BEdition3.indb8 2016/03/1811:20:342016/03/1811:20:34