Mazda mx-5 2016 - Page 416

7 – 8
If Trouble Arises
Flat Tire
10. Install the bottle to the air compressor
and press it in until the left and right
tabs are engaged securely.
Tabs
11. Insert the air compressor plug into the
accessory socket inside the vehicle and
switch the ignition to ACC.
Refer to Accessory Sockets on page
5-133 .
Compressor
Compressor plug
CAUTION
When inserting the air compressor
plug into or removing it from the
accessory socket, make sure that the
air compressor switch is o . When
turning the air compressor on/o , use
the air compressor switch.
12. The sealant is injected into the tire
when the air compressor is switched
on. After the sealant is injected
completely, wait until the tire inÀ ation
pressure increases to the speci¿ ed tire
inÀ ation pressure.
N O T E
The inÀ ation pressure may increase to
about 300 kPa (3.1 kgf/cm
2
, 3 bar, 43.5
psi) temporarily to inject the sealant
through the valve. Normally, the inÀ ation
pressure decreases gradually and it
reaches the actual inÀ ation pressure after
about 30 seconds.
WARNING
Never use the air compressor above 300
kPa (3.1 kgf/cm
2
, 3 bar, 43.5 psi):
Using the air compressor at an
in ation pressure above 300 kPa (3.1
kgf/cm
2
, 3 bar, 43.5 psi) continuously
is dangerous. If the air compressor
overheats, hot air will be exhausted
and you could get burned.
MX-58EU4-EA-15DEdition4.indb8MX-58EU4-EA-15DEdition4.indb8 2016/01/2010:56:442016/01/2010:56:44