MB Connect Line mbNET Series - 3. Safety Instructions

- 10 -
Label Status Description
Pwr
(Power)
LEDo󰀨
Routerpowersourceisswitchedo󰀨orrouterisnotconnectedto
powersource/powerpack.
LEDon Powersourceisconnectedtoterminalblockandswitchedon.
Rdy
(Ready)
LEDashing
TheReadyLEDdoesthisforapprox.35secondswhenthede-
viceisswitchedon.Afterthis,ashingindicatesbootsequence.
Thismaytakeupto90secondsdependingonthetypeofdevice.
LEDon Therouterisready.
Fc1
(Function 1)
LEDo󰀨 SerialinterfaceCOM1notreceivingdata.
LEDon SerialinterfaceCOM1receivingdata.
Fc2
(Function 2)
LEDo󰀨 SerialinterfaceCOM1notsendingdata.
LEDashing SerialinterfaceCOM1sendingdata.
Fc3
(Function 3)
LEDo󰀨 SerialinterfaceCOM2notreceivingdata.
LEDashing
SerialinterfaceCOM2receivingdata.
OnifMPI:buscommunicationOK.
Fc4
(Function 4)
LEDo󰀨 SerialinterfaceCOM2notsendingdata.
LEDashing
SerialinterfaceCOM2sendingdata.
IfMPI:bustransferringdata.
Con
(Connect)
LEDo󰀨 NoconnectiontoInternetorVPN.
LEDon ConnectiontoInternet.
LEDashing
(1,5Hz)
VPNconnectionactive.
LEDashing
(3Hz)
InternetorVPNconnectionisbeingestablished.