MCCORMICK X60.50 - Gearshift lever; Speed range selector lever; Power Shuttle control lever

101
Operation
5
Speed range selector lever
Thespeedrangeselectorleverhasfourpossibleposi-
tionscorrespondingtothecreeper,low,standardand
highspeedranges.
Eachspeedrangeisidentifiedbyasymbolontheknob
ofthelever.
  Creeperrange(optional)
  Lowrange
 Standardrange

 Highrange
Tochangefromonespeedrangetoanother,disengage
thegearshiftclutchpedal,andbringthetractortoa
completestandstillbeforemovingthespeedrange
selectortoitsnewposition.
Power Shuttle control lever
AV-Leverforward:Forwardgears.
N-Neutral:Alwaysmovethelevertothispositionto
starttheengine.
RM-Leverbackward:Reversegears.
Fourleverpositions
equivalenttofour
speedranges.
Shuttlecontrollever.
Gearshift lever
The lever has 4 possible positions, corresponding to 4
totallysynchronizedspeeds.
To shiftgears inthe samerange,justoperatethelever
afterdisengagingthedrive,withoutstoppingthetractor.
Xtrashift warning lamps
Forwarninglampsandinformationontheinstrument
panel,seetheInstrumentsandProgrammingSectionin
thismanual.