McCulloch 250 - BREAKING IN A NEW ENGINE; STORING AND REMOVING FROM STORAGE

IF THE
E FLOODS
1. Place the
on its side with the spark arrester down.
2. Hold the throttle
full back and
the starter handle
until the
starts.
BREAKI
NEW
E
is as as in a new car
Run your for its first few minutes at one-third
Increase to about half-throttle and run for a few
minutes
Cut a few limbs or small at first. Make small
cuts and
the feel of your saw. Check your chain tension fre-
and make use of your chain oiler button. Re-
member your chain saw is a and its treatment
_ its first half-hour of and
how
well it will serve you.
It is also advisable and practice to run the new saw for the
first hour or so of its break-in with the carburetor ad-
for a richer fuel mixture than normal.
Look at the arrester ports the break-in
If, after a few hours of arrester has
a gray or white it is an indication that the emdne is
too hot
STORING R (HAl
SAW
Never store your chain saw without the
all the way in so
This will a
of
your
Pour about a of clean oil
_ _ hole into the combustion chamber. Pull the
starter handle at least twice. This will coat the interior of
the combustion chamber with oil. Replace the
3. Remove the chain and bar. Soak the chain in oil and oil the bar
groove.
4. Drain the fuel from the fuel tank.
5.
the chain in plasuc or it in a coffee can. Cover the
and bar .. with a canvas or sheet.
REMOVI
FROM
1. Remove the Pull the starter rope to clear
the of the excess oil and fuel mixture. Clean and
the spark plug gap or install a new
2. Fill the fuel tank with the correct fuel mixture. Fill the chain
oiler tank with the correct grade of oil. Follow the standard
8