McCulloch 250 - FUEL AND LUBRICATION; GASOLINE; OIL; CHAIN LUBRICATION

GASOU E
Lubrication of the internal of your chain saw is ob-
tained of oil with the
as you can find, are not
for chain saw and their continued use will result in poor
Mix oil and in the shown in the Fuel
Mixture Table.
the of oil and that you will use within
of
mixed fuel and
and
UU<'''"~H
of moisture on the inside of the
can and will result in water to the fuel. Gasoline stored over
looses its fractions into the atl110sp
when
used in your chain saw, will make your
mix the oil and 5"""U!<U
in your fuel tank. When oil and pour half of the
and all of the oil into your container. the container
and shake the container to mix the oil and Then add the
balance of the gasoline and shake the container
USE EXOTIC FUELS OR ADDITIVES TO
"''''TnT''' TmS ENGINE.
all
McCulloch Chain Saw Oil is the best oil to use when UHAUl5
fuel. It is for use in
""",,-UJl"'0 and it lubricates better than other oils at the
at which air-cooled engines
that less McCulloch Oil is to a
fuel mixture. If McCulloch oil is not two-
outboard oil. Do use automotive engine or re-
claimed oils.
6
MIXTURE
7 liters
If you run your chain saw with less oil in the fuel
mixture than the Table calls your will
become overheated and may be
If you add too much your chain saw will
run unevenlv and may power.
Your saw chain must be lubricated when it's running or
it will wear out very fast, Fill the chain oiler tank of your chain
saw with clean oil every time you fill the fuel tank, Use a
of SAE
30 motor oil when are above 40° F.,
and SAE 10 motor oil when go below 40°
. Avoid the use of reclaimed or dirty oils.