19. Screws for securing the charging station
20. Power supply (the appearance of the power
supply may differ depending on market)
21. Stakes
22. Measurement gauge for help when installing
the boundary wire (the measurement gauge
is broken loose from the box)
23. Coupler for the loop wire
24. Operator’s Manual and Quick Guide
25. Extra blades
26. Alarm decal
27. Rating plate
1.3 Symbols on the product
These symbols can be found on the product.
Study them carefully.
WARNING: Read the
user instructions before
operating the product.
WARNING: Operate the
disabling device before
working on or lifting the
machine.
The product can only start
when the main switch is
set to
1
and the correct
PIN code has been en-
tered. Turn the main
switch to
0
before carry-
ing out any inspections
and/or maintenance.
WARNING: Keep a safe
distance from the ma-
chine when operating.
Keep your hands and feet
away from the rotating
blades.
WARNING: Do not ride
on the machine. Never
put your hands or feet
close to or under the ma-
chine.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
Use a detachable power
supply as defined on the
rating label next to the
symbol.
This product conforms to the
applicable EC Directives.
Noise emission to surroundings. The
product’s emissions are set out in
Technical data on page 43
and on the
rating plate.
1054 - 001 -
Introduction - 5
To Next Page