McCulloch EAGER BEAVER 282 User Manual

a
6 OPERATI
NG I NSTRUCTIONS
6
6-2. TO STOP
THE
ENGINE
NormalStopping:
Flgure
61G
7. Onceengineslarts,leavethechokeinthe"START"
position
for 10 seconds, then move
choke to "RUN"
position.
(Figure-6-1
G)
NOTE:
Your unit is equipped
with a throttle advance
which also can be
used during starting.
(Figure
6-1H)
NOTE: lf engine fails
to start, after repeated
attempts,
refer to Troubleshooting
section.
NOTE:
Always
pull
starter
rope straight up. Pulling
starter at
an angle will cause rope
to
rub
against the
eyelet.
This friction will cause rope to
fray and wear
quickly.
Always
hold starter handle when
rope retracts.
Never let
rope snap back from
extended
position.
This
could
cause rope to snag or fray
and also damage
the
starter assembly.
Figure 6-2A
1.
Release throttle
trigger. Let engine
return to idle.
Extend
stader rope 4"-6"
to absorb strain on starter
components
when engine stops.
Push
and
hold
ignition stop
switch until engine stops.
Allow starter
rope to
retract slowly.
(Figure
6-2A)
6.3,
WARM ENGINE
START
Flgure 6-3A
1. Place choke
in
"START"
position.
(Figure
6-3A)
2. Grasp throttle
handle firmly, squeeze throttle trigger
to FULL
throttle
position.
3.
Pull
starter
rope briskly until engine
starts, but
no
more
than 6 times. Keep throttle
at FULL
position
until
engine runs smoothly.
4.
lf engine
doesn't start,
place
choke
in
"RUN" posi-
tion and
pull
starter
rope 5 more times. lf engine
still
does not start
it is
probably
flooded.
Wait
5 minutes
and repeat
procedure
with choke in
"RUN"
position
and throttle fullopen.
t0

McCulloch EAGER BEAVER 282 Specifications

General

Brand	McCulloch
Model	EAGER BEAVER 282
Category	Trimmer
Language	English